Intuitive - Additional heating options
COMFORT CONTROL
Our air & liquid heaters have a new control panel that will help to control your Autoterm heater more conveniently and most easily.
Heating modes for air heaters |
Heater will maintain set temperature by reducing the heating power, without shutting off the combustion process. * The temperature mode for Air 2D 12/24V and 4D 12/24V heaters in the 6355, 6350, 6260, and 6265 series versions have a new algorithm. In this mode, the heater acts normally by lowering power when it gets near the set temperature. However, if it goes past the temperature setpoint, the heater will turn off and wait until the temperature drops by 3 degrees below temperature setpoint before starting again Heater will operate constantly at set power level. Heater will operate till the temperature is reached 1°C above the set temperature, shut off the combustion process and start to ventilate till the temperature drops 5°C below the set temperature. When temperature drops, heating starts again. Heater will operate till the specified temperature is reached then shuts off the combustion process and ventilation. After the temperature drops by specified degrees heating will start again. |
Heating modes for liquid heaters
|
Heater will operate till the certain coolant temperature is reached then shuts off the combustion process. After the temperature of the coolant drops heating will start again. (only for FLOW 14D) Pre-heating mode with reduced power and fuel consumption. Temperature of the coolant is reached slower than in “Pre-heating mode.” (only for Flow 5) Heater will operate till the specified interior temperature is reached then shuts off the combustion process. After the temperature drops by specified degrees heating will start again. Temperature is read by control panel. *for setting up “Thermostat mode” see instructions for AIR heaters. |
Temperature sensor
|
|
Timers
|
Heating mode can be chosen for each timer. Set timer is active continuously till disabled
|
Status display
|
|
Wiring compatibility
|
|
AUTOTERM heater compatibility
|
|
Display dimensions (mm)
|
37 x 20
|
Control panel dimensions (mm)
|
|
Heating modes for air heaters |
Heater will maintain set temperature by reducing the heating power, without shutting off the combustion process. * The temperature mode for Air 2D 12/24V and 4D 12/24V heaters in the 6355, 6350, 6260, and 6265 series versions have a new algorithm. In this mode, the heater acts normally by lowering power when it gets near the set temperature. However, if it goes past the temperature setpoint, the heater will turn off and wait until the temperature drops by 3 degrees below temperature setpoint before starting again Heater will operate constantly at set power level. Heater will operate till the temperature is reached 1°C above the set temperature, shut off the combustion process and start to ventilate till the temperature drops 5°C below the set temperature. When temperature drops, heating starts again. Heater will operate till the specified temperature is reached then shuts off the combustion process and ventilation. After the temperature drops by specified degrees heating will start again. |
Heating modes for liquid heaters
|
Heater will operate till the certain coolant temperature is reached then shuts off the combustion process. After the temperature of the coolant drops heating will start again. (only for FLOW 14D) Pre-heating mode with reduced power and fuel consumption. Temperature of the coolant is reached slower than in “Pre-heating mode.” (only for Flow 5) Heater will operate till the specified interior temperature is reached then shuts off the combustion process. After the temperature drops by specified degrees heating will start again. Temperature is read by control panel. *for setting up “Thermostat mode” see instructions for AIR heaters. |
Temperature sensor
|
|
Timers
|
Heating mode can be chosen for each timer. Set timer is active continuously till disabled
|
Status display
|
|
Wiring compatibility
|
|
AUTOTERM heater compatibility
|
|
Display dimensions (mm)
|
37 x 20
|
Control panel dimensions (mm)
|
|